Uruchomienie, wykonanie: route [options] [command]
Jak działa ROUTE, co robi ROUTE: TCP/IP command. Add or remove entries in the routing tables maintained by routed. route accepts two commands: add, to add a route, and del, to delete a route. The two commands have the following syntax:
add [-net | -host] address [modifiers] del [-net | -host] address [modifiers]
address is treated as a plain route, unless -net is specified or address is found in /etc/networks. -host can be used to specify that address is a plain route whether or not it is found in /etc/networks. Using route modifiers, you can specify the gateway through which to route packets headed for that address, its netmask, TCP mss, or the device with which to associate the route; you can also mask certain routes. Only a privileged user may modify the routing tables.
If no command is specified, route prints the routing tables
Dostępne opcje, wywołanie ROUTE: Specify an address family to use with an add or del command. family may be inet, inet6, ax25, netrom, ipx, ddp, or x25. Perform command on the routing cache instead of the forwarding information base (FIB) routing table. Use netstat -r format to print routing table. Use twice to print extended information. Same as netstat -ree. Perform command on the forwarding information base (FIB) routing table. This is the default behavior. Print help message, then exit. Show numerical addresses; do not look up hostnames. (Useful if DNS is not functioning properly.) Verbose mode. Print version and configuration options, then exit.
- Co znaczy :
- Porównanie remote host, or, if no command is specified, begin an interactive shell on the remote host using rlogin . The options can be specified before or after host . Use of rsh has generally been replaced co znaczy.
- Krzyżówka :
- Dlaczego System administration command. Display the previous and current system runlevels as reported in the utmp file. The default utmp file is /var/run/utmp . See init for a summary of runlevels krzyżówka.
- Co to jest :
- Jak lepiej Reverse the order of characters on each line of the specified file and print the results on standard output. If no file is specified, rev reads from standard input co to jest.
- Słownik :
- Kiedy Report RPC information. program can be either a name or a number. If a version is specified, rpcinfo attempts to call that version of the specified program . Otherwise, it attempts to find all the słownik.
- Czym jest :
- Od czego zależy Generate an index for archive file filename . This is equivalent to running ar -s czym jest.
Użycie ROUTE zastosowanie komendy na linii poleceńw Słownik R .
