komenda traceroute użycie co to jest
Jak użyć TRACEROUTE? Definicja w konsoli network host. traceroute attempts tracing by launching UDP.
Znaczenie komenda traceroute użycie definicja.

Czy przydatne?

Komenda/polecenie: Jak użyć traceroute

Uruchomienie, wykonanie: traceroute [options] host [packetsize]

Jak działa TRACEROUTE, co robi TRACEROUTE: TCP/IP command. Trace route taken by packets to reach network host. traceroute attempts tracing by launching UDP probe packets with a small TTL (time-to-live), then listening for an ICMP "time exceeded" reply from a gateway. host is the destination hostname or the IP number of the host to reach. packetsize is the packet size in bytes of the probe datagram. Default is 40 bytes

Dostępne opcje, wywołanie TRACEROUTE: -d

Turn on socket-level debugging.

-f n

Set the initial time-to-live to n hops.

 -F

Set the "don't fragment" bit.

 -g addr

Enable the IP LSRR (Loose Source Record Route) option in addition to the TTL tests, to ask how someone at IP address addr can reach a particular target.

 -i interface

Specify the network interface for getting the source IP address for outgoing probe packets. Useful with a multi-homed host. Also see the -s option.

 -I

Use ICMP ECHO requests instead of UDP datagrams.

 -m max_ttl

Set maximum time-to-live used in outgoing probe packets to max-ttl hops. Default is 30.

 -n

Show numerical addresses; do not look up hostnames. (Useful if DNS is not functioning properly.)

 -p port

Set base UDP port number used for probe packets to port. Default is (decimal) 33434.

 -q n

Set number of probe packets for each time-to-live setting to the value n. Default is 3.

 -r

Bypass normal routing tables and send directly to a host on an attached network.

 -s src_addr

Use src_addr as the IP address that will serve as the source address in outgoing probe packets.

 -t tos

Set the type-of-service in probe packets to tos (default 0). The value must be a decimal integer in the range 0 to 255.

 -v

Verbose; received ICMP packets (other than TIME_EXCEEDED and PORT_UNREACHABLE) will be listed.

 -w wait

Set time to wait for a response to an outgoing probe packet to wait seconds (default is 5).

 -x

Toggle IP checksums, usually to turn them off. IP checksums are always calculated if -I is specified.

 -z msecs

Set the delay between probes, in milliseconds. The default is 0.

Co znaczy :
Definicja command, passing it any arguments , and time the execution. Note that there is also a shell time command, so you might need to specify the full path, usually /usr/bin/time , to run this version of co znaczy.
Co znaczy :
Definicja System administration command. Signal init to change the system's runlevel. telinit is actually just a link to init , the ancestor of all processes krzyżówka.
Co znaczy :
Definicja See groff co to jest.
Co znaczy :
Definicja restore files from an archive medium. If any files are directories, tar acts on the entire subtree. Options need not be preceded by - (though they may be). The exception to this rule is when you are słownik.
Co znaczy :
Definicja Display system load average in graph format. If tty is specified, print it to that terminal czym jest.

Użycie TRACEROUTE zastosowanie komendy na linii poleceńw Słownik T .

  • Dodano:
  • Autor: